Yamaha Powersport Forums banner
Cancel

Clutch sensor

203 Views 2 Replies 2 Participants Last post by  Jolly_wrencher, 
Jolly_wrencher
Hello everyone. I just bought a Yzf 600r with 43,000 miles. It wouldn’t shift at first but I replaced the shift shaft and now shifts. But when I put it in gear it dies. It will only run in neutral. So I traced the wiring for the clutch lever below the gas tank and it was cut at the connection and now in lost. Does anyone know where the rest of the wiring runs to so I can replace? I attached a pic below. The rest is completely gone and I can see anything other than this cut.
Hand Finger Carabiner Wood Sleeve
See less See more
Reply
Save
Like
1 - 3 of 3 Posts
Lesblank
This is the neutral switch.

www.ebay.com

97-07 Yzf600r Yzf600 Yzf 600 Neutral Safety Switch Sensor | eBay

Find many great new & used options and get the best deals for 97-07 Yzf600r Yzf600 Yzf 600 Neutral Safety Switch Sensor at the best online prices at eBay! Free shipping for many products!
www.ebay.com

Audio equipment Jewellery Natural material Wire Event
See less See more
Reply
Save
Like
Jolly_wrencher
The blue connector turned out to be the kickstand wires. I traced them back up and they were cut. I soldered the wires back into the connector and the bike works now. Thank you!
Reply
Save
Like
  • Like
Reactions: 1
1 - 3 of 3 Posts
Yamaha Powersport Forums
A forum community dedicated to Yamaha powersport owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
General Bike Discussion FZ's, FZR's, & YZF 750 New Member Introductions YZ-F & YZ Mechanical / How To
Top