Yamaha Powersport Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Dual Purpose
    Chaps, my 1991 XT350 is driping fuel out the overflow outlet (at the very bottom of the bowl) at about 1 drop every 3-5 s. I have replaced the needle and seat, making sure to clean the hole into which the seat is mounted. I have checked the float height - it was 28mm and the manual says 27mm...
  2. Mechanical / How To
    Hi guys. i’m new to the 2 stroke/carb bikes. i got a yz250 and recently put in a new 8oz flywheel. ever since then i start to notice the bike kinda acts differently. cold starts with chokes revs the bike up super high, bike sounds a little off when it’s cold, deceleration has a little hop to it...
  3. Mechanical / How To
    Hey this is my first post just looking for some advice. I bought a 06 Yz85 about a month ago, I cleaned the carb, changed the air filter, and put a new spark plug and changed the tranny oil and coolant. The bike starts up 1st kick but it wont stay idling and its not running right it sounds lower...
  4. Mechanical / How To
    I have a 94 FZR 600 that the previous owner dropped on the left side. The can now has a small hole. I am thinking about going with a slip on. If I do is it necessary to have carb work done? second any recommendations on a brand? thanks for any help.
  5. FZ's, FZR's, & YZF 750
    I have owned this bike since day one and have added a vance & hines ss2r slip on, dyna jet stage 3 jet kit and a k&n stack to the motor. The bike ran great for 8 years with this set up and then I started having carb problems so I took it to the dealer for repair and they told me the jets were...
  6. Mechanical / How To
    I bought a 1986 Yamaha Fazer, and it desperately needed a tune up. I have cleaned the carbs (among many other things) and reseated them in the boots. They are definitely seated properly in the boots, but when I put the air cleaner box back on (new K&N filter), the joints don't quite fit over...
  7. Mechanical / How To
    I just bought a 1988 Moto-4 350 2-whl drive. I noticed fuel leaking from some sort of carb vent or over-flow tube. After inspecting further, I find 3 tubes coming off the carb, all 3 being open-ended and not connecting to anything: 1) tube off top of carb routed to the front (vent?) 2) tube of...
  8. TT
    I've had a ttr90 for about 2 years now and I'm finally getting it to the point where it witll run again. My brother blew the motor and I have replaced the whole top end. After I just got the timing done, the carburetor is acting up and is spitting gas out of the air filter and the bike won't...
1-8 of 8 Results
Top