Yamaha Forum : Your Yamaha Motor Products Community & Resource - View Single Post - 2000 timberwolf yfb250fw middle drive seal
View Single Post
post #3 of (permalink) Old 12-15-2011, 06:51 AM Thread Starter
tman
Junior Member
 
Join Date: Dec 2011
Posts: 3
 
It was definitely pressed in from the inside behind a pressed in bearing. I have completed the project and fixed the issue but there was definitely some poor design around that! By pulling the swing arm and then using a low profile box end wrench to get the u-joint nut off I was then blocked by the cross over frame rail. I cut out the rail removed the middle drive (repaired and re-installed it) then welded the frame rail back into place. This was by far easier than pulling the complete engine
tman is offline  
 
 
For the best viewing experience please update your browser to Google Chrome