Welcome to the Yamaha Forum : Your Yamaha Motor Products Community & Resource forums.
You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact contact us.
|FZ's, FZR's, & YZF 750 FZ-600, FZ-700, FZ-750, & YZF-750|
||Thread Tools||Display Modes|
|07-26-2012, 02:38 PM||#1|
Join Date: Apr 2012
Cam Timing Adjustment
Anyone know how to adjust the cam timing on the YZF 750? Factory Pro recommends 106-108 Intake and 101 Exhaust on the stock cylinder head (with their kit I would assume). I've been what research I can but there is little to no info about the bike. I think they are talking about degreeing the cams just going off the number spec. Any write ups or diys I'm missing here?
|07-26-2012, 03:22 PM||#2|
Join Date: Feb 2011
Bike: yzf 750/1000 ow01
firstly can i ask why you would want to adjust it ?
or do you mean how to check if the cams are installed properly
after a rebuild,
if you just want to check if theyre installed properly follow these simple steps:-
1 take off the cam cover
2 take out the sparkplugs
3 put the bike in 6th gear
4 if you are looking at the bike from the front, on the right hand side of the engine will be a timing window,
this will have a flat slot in to undo
5 once you've opened the timing window, turn the back wheel
until the T marker inside lines up with the marker on the casing
6 your engine is now at top dead centre - you will also notice
the exhaust cam lobes are pointing towards the front,
and the inlet lobes are pointing the opposite way.
7 there are 4 blocks bolting bown the camshaft holding it in place,
the block on cylinder number 3 (this is the one to the left of the cam sprocket in the cenre of the engine)
there will be a line marker on the block near the sprocket, the sprocket will also have a dot punched into it, these markers should be lined up for both the inlet and exhaust cams.
once this is all checked, make urself a nice cup of tea
and sit and look at your bike, talking to it like i do
|Thread||Thread Starter||Forum||Replies||Last Post|
|YZF 750 cam timing||TDMan||Yamaha-Forum Site Support Forum||1||01-25-2012 02:47 AM|
|yzf750 cam timing marks||kneedown||FZ's, FZR's, & YZF 750||0||08-10-2011 03:05 AM|
|shift cam fork||jsrcy||Mechanical / How To||3||06-27-2009 01:01 AM|
|GoPro Motorsport cam kit||moto||Motowheels||0||04-08-2009 01:55 PM|
|APE manual cam tensioner||skipper06||YZF-R1||24||11-04-2007 09:58 PM|