so last weekend i was bored and decided to adjust my trailer. the bucks were to close on the trailer and didnt allow the ski to sit right and made it a little difficult when loading.
the original set up
http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0013.jpg

http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0021.jpg

the first steps was to remove the bunks from the trailer and remove the brackets and staples.

http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0032.jpg

after the carpet is removed we cut two 45 degree angles to allow the hull to properly sit on the bunks.

http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0043.jpg

http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0034.jpg

then i recovered the boards i used a bolt to help line up the carpet and hold it as i stretched the fabric
http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0045.jpg

then reinstall the brackets and mount to the trailer. i used a floor jack (with a small piece of soft wood to protect the hull ) to lift the ski to adjust the bunks.

and the final results.
http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0054.jpg
http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0053.jpg
http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0055.jpg
http://i248.photobucket.com/albums/gg180/Stingray152003/IMG_0058.jpg

Much better..... :)

Most trailers don't come setup properly so you did the right thing. :0

Much better..... :)

Most trailers don't come setup properly so you did the right thing. :0

it slid on the trailer easier it really is much more stable now. next week im installing an intake grate i might do a little write up on that to.

I had Riva Intake grates on mine and loved them. You will notice a difference once you can get the water through the pump.

Looks good. Nice job :thumbup


Ride safe.